The wear-resistant ring length is made of polyurethane, polytetrafluoroethylene, fabric-filled synthetic resin and other materials. The width of the piston is determined by the size of the sealing ring and the necessary length of the sliding section. The sliding part is too short, which can easily cause early wear and jamming.
Cylinder with guide rodThe installation form should be determined according to factors such as installation and purpose of use.
In general, a fixed cylinder is used. The cylinder with a guide rod is easy to install. It is fixed with screws from all sides of the cylinder body, or it is fixed with screws from all sides of the cylinder body, or The flange-fixed bearing part can be filled with oil from the oil nozzle and equipped with a hydraulic buffer, so the cylinder movement speed is high and the impact absorption ability is strong.
Four installation methods of cylinder with guide rod
Installed above:
Install below:
Bottom installation:
Install under the T-shaped slot:
The above is the introduction of Four installation methods of cylinders with guide rods. Want to know moreCylinder< /strong>Related information can be viewed at www.diancifa.cc.
WhatsApp: +8615857777578