How to repair the automatic reciprocating cylinder if it leaks?

Automatic reciprocating cylinderFaults may occur during work, and cylinders are common The most common fault is cylinder leakage. There are many reasons for cylinder leakage, including internal leakage and external leakage. Below, Shenwei Pneumatic will answer your questions about why automatic reciprocating cylinders always leak and how to repair cylinder leaks.

▋ The principle of external leakage of automatic reciprocating cylinder and how to repair it

1. The fixed seal between the cylinder block and the cylinder head of the automatic reciprocating cylinder is poor. The sealing ring should be replaced in time.

2. The reciprocating motion between the piston rod of the automatic reciprocating cylinder and the cylinder head is poorly sealed. If the piston rod has scratches or is eccentrically worn, the piston rod should be replaced in time;if air leakage is caused by the quality of the sealing ring, the sealing ring should be replaced in time.

3. The regulating valve and one-way valve of the automatic reciprocating cylinder buffer device are leaking. Check carefully and replace the leaking regulating valve or one-way valve in time.

4. The fixing screw of the automatic reciprocating cylinder is loose. The screws should be tightened as required in a timely manner.

5. There are impurities between the piston rod and the guide sleeve of the automatic reciprocating cylinder. The impurities between the piston rod and the guide sleeve should be checked and cleaned in time, and the dust ring should be reinstalled.

The above isAutomatic reciprocating cylinder What should I do if there is a leak? Content introduction, want to know moreCylinderInformation can be viewed at Sunway Pneumaticwww.diancifa.cc.