AppCustomerCommentsContactGuide
My page Order listRegistration
Moving Image
SF Express nationwide free shipping, large items delivered to your door, daily shipment volume 50,000 pieces, corporate legal person, individual registration click hereLogin registrationLog out

Knowledge Classification

√ Recently Viewed Products

    Snway PneumaticProduct KnowledgeCylinder knowledge

    Air source triple piece

    Author:Source:Update time:2024-11-02 12:44:49 Read:
    Air source triple unit



    In pneumatic technology, The three air source processing components of air filter, pressure reducing valve and lubricator are assembled together and are called pneumatic triple parts, which are used to enter the air of pneumatic instrument

    Source purification, filtering and pressure reduction to the rated air source pressure supplied by the instrument is equivalent to the function of a power transformer in the circuit.
    Features
    The air filter pressure reducing valve is light and small in design and easy to install. Therefore, it can be installed and used together with pneumatic transmitters, pneumatic regulators and other products. If the pressure reducing valve of the air filter is designed as a whole, it becomes a two-piece. The air source treatment trio includes air pressure reducing valve, filter and oil mist device

    . The pressure reducing valve can stabilize the pressure of the air source so that The air source is in a constant state, which can reduce damage to hardware such as valves or actuators due to sudden changes in air pressure.

    The filter is used to clean the air source and can filter the moisture in the compressed air to prevent moisture from entering the device with the gas. The lubricator can

    lubricate the moving parts of the body and lubricate parts that are inconvenient to add lubricating oil, greatly extending the service life of the body.
    Installation
    1. Please pay attention to cleaning the connecting pipes and joints during installation to avoid bringing dirt into the air path.
    2. When installing, please pay attention to whether the direction of gas flow is consistent with the direction pointed by the arrow on the body, and whether the shape of the pipe and joint is correct.
    3. Fix the filter, pressure regulating valve (pressure regulating filter) and oil feeder;match the convex groove of the fixing bracket with the groove on the body, and then use the fixing piece and
    < div>
    Just tighten the screws.
    4. Fixing the pressure regulating valve and pressure regulating filter when used alone;just rotate the fixing ring to lock the attached special fixing piece.
    Instructions for use
    1. There are two ways of filter drainage: pressure difference drainage and manual drainage. When draining manually, it must be drained before the water level reaches the level below the filter element.
    2. When adjusting the pressure, please pull up and then rotate the knob before turning it. Press down the knob to position it. Turn the knob clockwise to increase the outlet pressure, and turn it counterclockwise to decrease the outlet pressure. When adjusting the pressure, it should be adjusted gradually and evenly to the required pressure value, and should not be adjusted in one step.
    3. How to use the oil feeder: The oil feeder JIS K2213 delivers engine oil (ISOVg32 or equivalent oil). Please do not fill the cup more than 80% full. The number

    The number O means the smallest amount of oil, and 9 means the largest amount of oil. It cannot rotate from the 9-0 position, and the hour hand must rotate.
    Notes
    1. Some parts are made of PC material and are prohibited from being used close to or in an organic agent environment. Please use neutral detergent to clean the PC cup.
    2. Do not use pressure exceeding its usage range.
    3. When the outlet air volume is significantly reduced, the filter element should be replaced in time.

    Previous:Cylinder specifications and modelsNext:Features of Airtac
    Loading...