How to repair gas water heater solenoid valve failure

Gas water heater electromagnetic How to repair valve failure

Gas water heaterSolenoid valveHow to repair the fault? If the water pressure is normal, but the water pressure of the hot water faucet or shower is abnormal, it may be that the hot water faucet or shower is clogged. Just clean it and restore the normal water pressure.

If the water outlet pressure is normal but there is no ignition sound, first check whether the battery has poor contact or no power. If the battery is normal, it is mostly due to poor contact of the main switch of the water control power supply. Open the shell of the water heater and check. There is a small iron piece pressing a small contact on the right side of the water control power main switch installed at the lower part of the water heater. Pressing it will turn it off, and releasing it will turn it on. You can try to loosen the switch by dialing a small iron piece. If it is normal, it will ignite immediately. If it still does not ignite, most of the time the switch is broken (the damage rate of this switch is very high), just buy another one and replace it.

The solenoid valve is faulty

< /p>

Solenoid valve failure is one of the common reasons why the water heater does not ignite. When the water heater is igniting, if you only hear the sound of ignition but not the solenoid valveSolenoid valveThe sound of magnetic attraction, then this It means that the solenoid valve has been aged or damaged. In addition, the solenoid valve is dirty and blocked, which will also cause the water heater to not ignite normally. During maintenance, damaged or aging solenoid valves need to be replaced;if there is a dirty blockage, the solenoid valve needs to be cleaned to ensure that the water heater can ignite normally.

The above isHow to repair a gas water heater solenoid valve failure Content introduction, if you want to know more related information, you can Log in to www.diancifa.cc to view.