The difference between 10a-5 cylinder and SC cylinder, 10a-5 cylinder model specifications

The difference between 10a-5 cylinder and SC cylinder

SC cylinder and 10A-5 are two series. Their installation dimensions are different. SC: It was the size standard of AirTAC in the early days. Later, many domestic manufacturers followed this standard. Some were also called SC, and some changed their names. 10A-5 is an early national standard. The two series only have slightly different mounting holes. If it is an accessory connection, it can be replaced, but CylinderIf it is installed directly on the machine, it cannot be replaced unless the mounting holes are re-drilled. The 10a-5 cylinder is sealed with steel pads and steel sleeves, which are better and more durable than rubber seals. Using a brass sleeve as a guide reduces wear on the piston rod during operation, resulting in a longer service life than SC.

10a-5 cylinder model specifications

Features

1. The technology of Japan Taiyo Iron Works Co., Ltd. (TAIYO) is introduced and the oil-free lubrication cylinder is produced under the company's license.

2. "Three Excellent Products" - "Provincial Excellent", "Ministry Excellent" and "Famous Excellent" products.

3. Advanced level in the 1980s. The main parts are made of aluminum alloy and are light in weight. The cylinder wall is hard anodized, which is particularly wear-resistant and has a long service life.

4. The installation size complies with ISO (international standard)

5. No oil (oil can also be added) for lubrication to avoid oil and gas pollution, which can be omittedOil mist device.

6. Various specifications, available for belt openingClosing and valved combined cylinder saves time on taking over and is easy to maintain and operate.

10a-5 cylinderMain technical parameters

Note:

1. When the switch type cylinder is equipped with a switch in the middle position, the maximum speed of the cylinder should be within 300mm/sec, so that the response speed of the relay and other loads can be Adaptable,work in good condition.

2. The switch must be loaded before it can be used, otherwise any direct power supply will be burned.

3. When the shortest stroke of the switch-type cylinder is less than the value specified in the above table, an imported switch can be installed. Please add "" after the model number when ordering (Imported switch)" words,price is extra.

That's itThe difference between 10a-5 cylinder and SC cylinder, 10a-5 cylinder model specifications and parameters Content introduction, if you want to know more related information, please log in to Sunway Pneumatic span>View at www.diancifa.cc.