What is a cylinder repair kit, cylinder repair and maintenance methods

What is a cylinder repair kit

The cylinder repair kit is used to repair the cylinder if it leaks.

Determined based on inspectionCylinder RepairPlan:

1. There is internal leakage in the cylinder. No air leakage can be seen from the outside, but the thrust (or pulling force) of the cylinder is insufficient. Disconnect the exhaust port and check that there is air discharge. Check Replace the piston ring seal and check whether the inner wall of the cylinder barrel is worn or roughened.

2. If air leaks outside the cylinder, replace the relevant rod seal and dust ring.

3. When the cylinder runs to the terminal where the impact force is strong, reduce the buffer port.

4. When the cylinder runs to the terminal speed, the speed drops significantly, and the thrust cannot meet the requirements. Check and clear the buffer air port.

5. The inner wall of the cylinder barrel is severely worn. Check and replace the guide band on the piston rod.

Do a good job in maintaining thecylinder on a daily basis, and use a clean air source. A pneumatic triplet needs to be installed for lubrication and filtration. Once oil mist lubrication is carried out in the air source, it must be ensured that it cannot be interrupted and there must be continuous oil in the lubricator.

1. The use of the cylinder should comply with relevant safety regulations. When a failure occurs, there should be an emergency stop device. After processing, the compressed air should be discharged from the cylinder.

2. All parts of the cylinder that are used should be checked regularly for abnormalities, loose joints, and the cylinder where the movable part of the shaft pin is installed should be lubricated regularly.

3. When the cylinder is not used for a long period of time, the cylinder surface should be coated with full qgb anti-rust oil processing, and the inlet and exhaust ports should be added to the dust clogged.

4. Reassemble the cylinder for maintenance. The replacement must be clean. Dirt may not be brought into the cylinder. In particular, it is necessary to prevent the sealing ring from being cut and damaged, and pay attention to the installation direction of the movable sealing ring.

5. Formulate the monthly, quarterly and yearly maintenance system for cylinders and work accordinglycylinder, the piston will hit the cylinder head, and the cylinder head gasket is a consumable buffer. If serious If the buffer ring is damaged, before the end of the stroke of the cylinder, the buffer plunger and the buffer ring will not have a good seal, thus losing the buffering effect. When the cylinder is used for a long time, it is usually necessary to replace the seals and grease.

That's itWhat is a cylinder Maintenance kit, cylinder repair and maintenance methodsContent introduction, if you want to know more related information, please log in to Sunway Pneumaticwww.diancifa .cc view.