In recent years, with the rapid development of the automation industry, cylinders have gradually become known to people. What follows is a variety of problems that arise in the application of the cylinder. The issues we discuss today are:such asHow to adjust the cylinder speed.
There are many factors that affectcylinder speed, such as cylinder bore size, solenoid valve flow aperture ;The air pressure used, the diameter and length of the air pipe, the air storage capacity of the air compressor, the position of the air path of the control component, etc. will all have a certain impact on the speed of the cylinder. At this stage, there are two ways to affect the speed of the cylinder: whether the cylinder can achieve fast or slow effects: 1. The cylinder needs to be equipped with a speed regulating device, and a speed regulating valve is installed at the air inlet and outlet of the cylinder;2. The exhaust valve device is also in An exhaust valve (relief valve) device is installed at the air inlet and outlet of the cylinder. Let's take a look at how to adjust the cylinder speed using these two factors?
Generally, the cylinder has two air chambers, so there are two air inlets on the cylinder body. If the air hole near the end of the cylinder is in the air intake state, then the push rod in the cylinder extends outward. On the contrary, if the air hole near the push rod is in the air intake state, then the push rod in the cylinder contracts inward. Solve it according to the throttling method. 
First prepare auxiliary accessoriesauxiliary accessories
One two-position five-way solenoid valve, nylon tube, and two throttle valves. At this time, connect the main air source pipe to the P port of the solenoid valve, and then connect two air pipes to the solenoid valve A and B ports respectively. At the same time, each branch is connected to a throttle valve, and then the air pipe is led from the throttle valve to the cylinder. Connect the two air intake inlets of the four-tie rod cylinder respectively. Pay attention to the air opening and closing, and take over the pipe correctly according to the specific process requirements.
After all the assembly work is completed, it is time to debugCylinderSpeed, use a throttle valve to adjust the air intake of the cylinder. If the retraction is required to be slower, the air volume in the descending air path should be reduced;if the extension is required to be faster, the air volume in the ascending air path should be increased. How much gas volume should be adjusted depends on actual requirements.
The above is the introduction of Teach you how to adjust the cylinder speed, if you want to know more For more relevant information, please log in to www.diancifa.cc.
WhatsApp: +8615857777578