How to choose a cylinder

How to choose a cylinder? Please contact Sunway Pneumatic Company! We have professionals to answer your questions!

Cylinder problem

Linear repetitive motion is the most trouble-free and time-saving motion, but on the cylinder, its motion still exists Serious defect issues.

The first point is the problem of buffering. When the cylinder is operated at such a high frequency, the solenoid valve cannot switch the valve position normally, even if it is a solenoid valve. The coil is fine, but after a short time, the coil will generate a temperature rise due to high-frequency switching, and will eventually fail or burn out. If the cylinder itself does not have a buffer, the damage to the cylinder will be great, and the buffer of the cylinder It takes time to complete.

In addition, the inherent characteristics of compressed gas also determine the frequency you need to rate. Normally, if you can achieve the requirement of 2 times/s, it is considered very good. of the cylinder. In the process of use, our company has not developed any kind of cylinder through long-term monitoring, including festo products, which cannot meet your technical requirements. We hope that you will change your thinking mode and switch to design

.

It needs to reach a frequency of 10 times/s. The one I have used has not appeared yet. If you think about it, it is 600 times a minute. At this time, there are really only other institutions that can achieve what you need. Frequency requirements, such as the crank connecting rod mechanism, using a reducer with appropriate speed as the power source, when achieving variable frequency control, the operating frequency you need can basically be achieved.