Precautions for use and installation of swing cylinder

Please install and use the product after carefully reading and correctly understanding the content. Pleasekeep it properly for ready use.

2. Ensuring maintenance space

Please ensure space required for maintenance inspections.

3. Tighten the threads and strictly observe the tightening torque

When installing, tighten the threads according to the recommended torque.

4. Before adjusting the angle of the air supply, please take measures to prevent itSwing cylinderUnnecessary rotation.

Before performing angle adjustment when supplying pressure, the device may rotate due to different installation postures during adjustment If it falls, it may cause damage to people, components and devices.

5. Do not loosen the angle adjustment screw too much and exceed the adjustment range.

Prevent the angle adjustment screw from falling off, causing damage to people, components and devices.

6. Do not get close to external magnetic fields.

The magnetic switch is a magnetic field induction type. If it is close to an external magnetic field, it may cause malfunction.Personal, Damage to components and devices.

7. Please do not reprocess the product.

Prevent the product from being damaged due to insufficient strength, causing damage to people, components and devices.

8. The fixed orifice in the piping interface must not be enlarged.

To prevent the product from increasing the swing speed, the impact force, and product damage, resulting in personal injury, Damage to components and devices.

Otherwise, abnormality may occur due to eccentricity, resulting in malfunction, product damage, and causing personal injury, Damage to components and devices.

10. Do not impose a value on the shaft that exceeds the allowable shaft load recorded in the product catalog.

If a load exceeding the allowable value is applied to the product, it may cause malfunction or damage, resulting in Damage to the human body, components, and devices.

Can withstand the allowable radial and axial loads when there is no dynamic load. Try to avoid placing load directly on the shaft as much as possible. In order to optimize the actionconditions, it is recommended to use the loading method as shown below without directly adding load to the shaft.

11、< strong>The external stopper should be installed away from the rotary axis.

If the limiter is installed near the rotary axis, the swingCylinderThe torque generated by itself is limitedThe reaction force generated on the positioner is added to the rotary shaft, causing damage to the rotary shaft or bearing, causing damage to people, components and devices.