SC standard cylinder size table

Regarding the knowledge of SC standard cylinder size table, the editor of Shenwei has compiled a complete information for your reference. First, here is a picture of the SC standard cylinder for everyone to enjoy!





SC standard cylinder pictures


1. About the code meaning of SC standard cylinder:








2. The SC standard cylinder installation size table is as follows:








3. SC standard cylinder product features:
1. The piston seal adopts a special-shaped two-way sealing structure, which is compact in size and has oil storage function;
2. It is a tie rod type cylinder, and the front and rear covers are connected to the aluminum tube cylinder body with pillars, which has good reliability;
3. Compared with ISO15552 standard cylinder, the SC series cylinder with the same bore diameter is smaller in length;
4. The cylinder buffer adjustment is smooth;
5. Various specifications of cylinders and cylinder installation accessories are available for customers to choose from;
6. Select high-temperature resistant sealing materials to ensure that the cylinder operates normally at 150°C.






Further reading:


Introduction to standard cylinders:


1. Standard cylinders are suitable for use in all walks of life. Cylinders dedicated to dust removal equipment are generally used with poppet valves and electromagnetic pulse valves. The company customizes cylinders with different bores and strokes, cylinder flanges, and cylinder matching units according to the specific requirements and needs of customers. Ears and ears, as well as cylinder standard air rods and cylinder extended air rods, etc. The compressed air enters the air source treatment component. After being filtered, decompressed, and lubricated, dry, clean, and lubricated air with a certain pressure enters the cylinder through the solenoid valve.

2. The solenoid valve receives the signal from the electric control cabinet, controls the cylinder action, and realizes automated processes such as cold air, ash unloading, offline ash cleaning, and back-blowing conversion. Standard cylinders can be divided into: 63, 80, 100, and 125 specifications. Normal working conditions of the cylinder: medium and ambient temperature are -5~70℃, working pressure is 0.1~1Mpa. Cylinder movement speed range is 50~500mm/S. Solenoid valve K25JD to 25 series two-position five-way cut-off directional valve It can be divided into five-port two-position/five-port three-position series specifications. The solenoid valve with appropriate diameter, voltage, connecting thread, and installation form must be selected according to the project requirements. It can also be selected according to the actual use.






Precautions
The following matters should be paid attention to when installing and adapting standard cylinders:
1. When the load changes during work, a cylinder with sufficient output power should be selected;
2. Under high temperature or corrosive conditions, corresponding high temperature resistant or corrosive cylinders should be selected;
3. In places with high humidity, dust, or water droplets or welding slag, the cylinder should take protective measures;
4. Before the cylinder is connected to the pipeline, the dirt in the pipeline must be cleared to prevent debris from entering the cylinder;
5. The medium used in the cylinder should be filtered by a filter element of more than 40um before use;
6. In low-temperature environments, anti-freeze measures should be taken to prevent the water in the system from freezing;
7. The cylinder should undergo no-load test operation before use. Before operation, the buffer should be adjusted to the minimum i and gradually abandoned to avoid damage to the cylinder;
8. The cylinder should avoid lateral loads as much as possible during operation to maintain the normal operation of the cylinder and extend its service life;
9. If the cylinder is not suitable for use for a long time after being disassembled, attention should be paid to the surface rust prevention, and the intake and exhaust ports should be prevented from being clogged with caps.






The above content is the detailed information about the SC standard cylinder size table introduced by the editor of Shenwei. If there is anything missing, please leave a message for guidance.