How to calculate the theoretical output pressure and thrust output of the cylinder and the comparison table

Regarding a series of common questions such as cylinder pressure calculation formula, cylinder thrust calculation formula, how to calculate cylinder output, cylinder thrust comparison table, cylinder theoretical output force table, etc., here, the editor of Shenwei will provide you with the most comprehensive cylinder theoretical output. Force tables and calculation methods, our company is an enterprise dedicated to serving automation series supporting and solutions. 1. The pressure and thrust output of the cylinder have nothing to do with the stroke length. For example: air pressure 0.5Mpa (4.903325 kilogram force/square centimeter (kgf/cm2)) cylinder diameter 50mm (5cm) cylinder cross-sectional area = 3.14X(5/2)^2= 19.63 (square centimeters). Therefore, the theoretical output under 0.5Mpa = 4.903325*19.63 = 96.253 (kg force). You can directly refer to the output table below, but it is only the theoretical output. The actual output depends on the working conditions. 2. Cylinder pressure thrust actual output force N =A*F 1. (Assume that the cylinder operates at 50~500mm/s, 50-bore cylinder. The theoretical output is 100 kg at 0.5Mpa air pressure, and 100 kg , low-speed riveting, etc.), F2 resistance is very small, A≥0.7;for horizontal or vertical movements with cylinder speed in the range of 50~500mm/s, A≤0.5;for movements with cylinder speed greater than 500mm/s, F2 has a great influence , A≤0.3. 2. For example, we estimate that a cylinder with a bore diameter of Φ40mm needs to be selected for a certain occasion. This is the bottom line, but there is no need to say, give a safety factor, and then choose an "accurate" bore. The actual approach is, It should be based on various considerations, you may choose a cylinder diameter of Φ50mm or Φ63mm or even Φ100mm. The determination of the cylinder diameter needs to be based on the load size, operating speed and working pressure. (1) Determine the relevant load weight: load conditions include workpieces, fixtures, guide rods and the weight of the movable parts. (2) Select the air pressure used: the compressed air pressure supplied to the cylinder (3) Action direction: determine the direction of the cylinder action (up, down, horizontal) 3. Standard single-rod cylinder theoretical pressure thrust output force table 4. Double-rod cylinder Theoretical output force table 5. Three-rod cylinder lateral load and pressure thrust torque force table The above content describes the cylinder pressure calculation formula, cylinder thrust calculation formula, how to calculate the cylinder output, cylinder thrust comparison table, and a series of related cylinder theoretical output force tables Question, hope it helps everyone. If there is anything you still don’t understand, please feel free to consult our Shenwei customer service staff and we will answer your questions carefully.