How to choose a cylinder for airtac

How to choose a cylinder for airtac

Airtac professionals gave us a brief introduction to the selection of pneumatic hoses. In addition to pneumatic hoses, the purchase of other pneumatic components is equally important. How to choose a cylinder? This problem also troubles many pneumatic component users. Industry insiders who have been engaged in pneumatic component agency and pneumatic component wholesale for a long time naturally have their own set of selection criteria, but for many "laymen", the choice of cylinder is indeed a difficult problem. The cylinder is the actuator in the pneumatic system, and the quality of the cylinder will directly affect the overall performance of the supporting equipment. Next, we will learn from Dingyu pneumatic component manufacturer and listen to how the experts choose cylinders.
1. Choose a pneumatic component manufacturer with a high reputation and a good reputation for quality and service.
2. Check the standards used by pneumatic component manufacturers to produce cylinders. If it is a corporate standard, it should be compared with the pneumatic component industry standards.
3. Inspect the appearance, internal and external leakage and no-load performance of the cylinder, which mainly includes three items: the appearance of the cylinder, the surface of the cylinder barrel and piston rod should be free of scratches, and the end cover should be free of pores and trachoma ;The cylinder is not allowed to have external leakage except the rod end. The internal leakage and the external leakage of the rod end should be less than (3+0.15D)ml/min and (3+0.15d)ml/min respectively;put the cylinder in a no-load device When it is running at low speed, see what the speed is without crawling. The lower the speed, the better.
4. Pay attention to the installation form and size of the cylinder. The installation size can be mentioned when ordering from the pneumatic component manufacturer. Since cylinders are generally not in stock, it is recommended to use standard models as much as possible to shorten delivery time.