Airtac solenoid valve 4V210 series

4V210-08 solenoid valve product features:
1. Pilot mode: external and internal optional;
2. Sliding column structure, good sealing and sensitive response;
3. Three-position electromagnetic The valve has three central functions to choose from;
4. The double-headed two-position solenoid valve has a memory function;
5. The inner hole is processed by a special process, with small friction resistance, low starting air pressure and long service life;
>6. No need for lubrication;
7. The valve group can be integrated with the base to save installation space;
8. A manual device is attached to facilitate installation and debugging;
9. A variety of standard voltage levels are available. .

Installation and use of 4V210-08 solenoid valve
1. Before use, please check whether the components are damaged during transportation, and then install and use;
2. When installing, please pay attention to the direction of gas flow and the correct shape of the connecting rod. . The media used must be filtered through a 40um filter element;
3. Please pay attention to whether the installation conditions meet the technical requirements (such as "voltage", "action frequency", "working pressure", "usage temperature range", etc.), and then install and use it;
4. Pay attention to the direction of gas flow during installation. P is the air inlet, A (B) is the working port, and R (S) is the exhaust port;
5. Try to avoid using it in a vibrating environment, and Pay attention to anti-freezing measures at low temperatures;
6. When connecting pipelines, be sure that the anti-leak tape cannot be wrapped beyond the tooth end of the joint. Pay attention to removing dust, iron filings and other dirt in the pipeline joints to prevent impurities or foreign matter from entering the valve body. ;
7. Please pay attention to dust prevention. It is recommended to install a muffler or silencer throttle valve at the exhaust port. When it is removed and not in use, dustproof boots should be installed on the air inlet and outlet.
8. When debugging the whole machine, it is recommended to debug it with manual device first, and then turn on the power for debugging.